INSTRUCTION MANUAL IF YOU PURCHASED THE CHAIR ONLINE AND HAVE ANY QUESTIONS OR CONCERNS PLEASE CONTACT US WITH EMAIL OR TEXT EMAIL: hiwarrantyservice@outlook.
WARNING: Proper use of the chair is for single person seating only. The chair is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only. Chair tested for use at weight of 300lb (136.4kg). Improper use of this product or failure to use as directed may result in injury. Not intended for commercial use. IMPORTANT: Please read all the instructions and warnings before assembling.
Step 1: Secure chair back (B) to left arm (A1) with 2 washers (J) and 2 screws (H) by using allen wrench (M). Do not fully tighen now. Note: The hole of chair arm must face inside of seat. Step 3: Secure seat panel (C) to assembled chair arms (A2.A2) with 4 washers (J) and 4 screws (I) by using allen wrech (M). Do not fully tighen now. Step 2: Secure right arm (A2) to the other side of assembled chair back (B) with 2 washers (J) and 2 screws ( H) by using allen wrench (M). Do not fully tighen now.
Step 5: Secure support bar (F) to swivel base ring (E) with 2 screws (H) and 2 washers (J) by using allen wrench (M). Do not fully tighen now. Step 7: Attach rocking base (D) to chair arms (A1.A2) with 4 nuts (K) and 4 screws (I) by using spanner (N) and allen wrench (M). Do not fully tighen now. Step 6: Secure support bar (G) to swivel base ring (E) with 3 screws (H) and 3 washers (J) by using allen wrench (M). Tighten all screws on Step 5&6 now.
Side Table Parts List: NO. Part Qty A Table Leg C E Image NO. Part Qty 4 B Glass Table Top 1 Table Tray 1 D Washer 12 Screw( 6x12mm) 12 F Allen Wrench 1 A STEP 1: Assemble 4 table legs (A) to glass table top (B) by using 8 screws (E) and 8 washers (D) with allen wrench (F). Do not tighten all screws now. E D E D E D Image F E E D D B E D E D E D E D F E STEP 2: Assemble table tray (C) to 4 table legs (A) by using 4 screws (E) and 4 washers (D) with allen wrench (F).
