a sh lil] TOY Tr ASSEMBLY AND OPERATION MANUAL Specifications: = ‘Alphas Race Boas Mods! No: 8001 Universal Assembly: Water cooled Powerful Out-runner brush less Motor(included) 2CH Digital Proportional Transmitter(Included) Water Cooled 930A Brush less ESC beck (Included) Powerful steering Skis high torque servo {Included) Two pos of two blade metal propeller (included) JE 5mm Flex Cable Direct Drive Two packs of 11.1V 5000maAh 40C Li Po Pack(Not included) Two packs of 7.
INSTRUCTION MANUAL ALPHA ART BRUSH LESS EP RACING BOAT THESE INSTRUCTIONS SHOULD BE READ BY A SUPERVISING ADULT 4. Transmitter 8. Alisn key {PCs) 2. Two pes of metal propeller 7 Boat stand with rubber cushion 3.Gold connectors wheat shrink-Fit to 8 Aluminum rudder & support Li Po batteries if not already filed 9.Alpha race boat 4 Rubber balloon & cable strap (For receiver) a Team & 5.5mm Spanner NOT INCLUDED) 1} Packs of 7.4Y 5000mAh{or greater) 40C{or greater) Li Po or 2} packs of 11.
Before using this Alpha model and its radio control system, and to ensure the safety of yourself and others, iris vary important that you read theses instructions thoroughly and understand them. Alpha model is capable of speeds in excess of Care should be taken to avoid the possibility of injury and/or property damage. Alpha model is designed for use in fresh water only.
The position of the rear shaft strut to the hull will have an effect on the way your boat performs. From & 5.5mm Spanner 1} Above adjustment is suitable for ! Bm Allen Key racing on fiat water surface 2} Above adjustment is suitable for racing on / 3) Above adjustment is suitable for racing on between light and medium wind and was. between medium and big wind and wave. IMPORTANT NOTE: 1. It is not suitable to race boat in too strong wind and wave. 2.
You should take steps to ensure that your Alpha mods! and #ts radio control equipment ars adequately protected against the possibility of water damage. Place your mods!'s receiver inside the included rubber bag {balloon} and tis the and off with a cable tis or similar. Ensures the propellers flexible shaft is properly lubricated Gm REEVES {see below} as this foo will reduce the possibility of water |S entering the hull during operation.
Attention: Before replacing the Alpha model's upper deck, check to ensure that the water-cooling tubing that connects to the motor is not obstructed or kinked, as this can cause the motor and speed controller to overheat and potentially burn out, Mote 1: Alpha models will typically run for around 4 minutes on fully charged Li-Po battery packs, although this will vary depending on the type and capacity of Li-F packs you choose.
RECEIVER =i 1% ESC THROTTLE SERVO Note: if ESC with BEC function, no need to connect battery with receiver. @ binding process effectively ties ths transmitter and receiver together. Under normal circumstances, both tams are supplied like this from the factory. If, however, you find that your transmitter and receiver are not bound(receiver's red LED is on}, you should do the following: 1} Switch “ON” the transmitter.
3.Pull the throttle & motor rotate in anticlockwise direction, your motor is now armed and ready for operation. 4.Check the direction of the rudder, the trailing edge of the rudder should turn right when right input is given. Conversely, when left input is given, the trailing edge of the rudder should turn left. 1} When you have finished using your Alpha model, you should first switch ‘OFF’ the mode! {disconnect the Li-Po battery packs), then switch “OFF your transmitting.
Function Uss this when performing left and right steering angle adjustments. End Point Adjustment (EPA) adjusting value range: Getting 1. Steering {right side) angle adjustment Rotate “ST/R” knob fo the left end point means minimum value 0%, right end point means maximum value 100%. 2. Steering {left side} angle adjustment Rotate "ST/L” knob fo the left end point means minimum values 0%, right end point means maximum value 100%.
Each Alpha model is supplied from the factory with radio and cooling systems already set up. However, if you have cuss to maintain, repair or replace parts in your model in the future, this chart can be of help when it comes time to everything.
Please observe the following warnings DURING OPERATION « Ensues that all batteries are comely installed and that the Li-Po battery packs ars fully charged. + Do not touch moving parts during operation, especially the propeller. = if you lose control of your Alpha model, never wade into deep water or water with strong currents to retrieve it. First, hold the transmitter as high 85 you can to fry to re-establish control.
Use blowing parts number in the parts list to order spare parts for Alpha boat. 880101 880102 880103 #920104 830108 890106 830107 880108 880109 890110 880111 890112 830113 890115 830118 830118 830119 &80121 880123 890124 830125 890126 830127 880128 830129 880130 82035 93017 850102 930512 880538 830518 230519 11.
