Owner's Manual

Figure 3
10
8
Illustration For Use
Note:
Oils or cosmetics on the forehead may give a lower temperature
reading than the actual one.
Do not use the thermometer on a perspiring or sweating forehead,
as this may affect the reading.
Remove dirt from the forehead before
taking a measurement. Wait at least 10 minutes after washing the
forehead area before taking a reading.
Remove hat and hair and wait 10 minutes before taking a reading.
Check before each use that the lens is intact. If it is damaged,
contact your retailer or the service address.
Bear in mind that the thermometer needs to have been in the room
in which the measurement is taken for at least 30 minutes before
use.
U
Before each measurement, make sure that the device is in the
appropriate mode for the measurement that you wish to take.
sers and the thermometer should be in the same ambient
temperature.
Before measurement:
To measure forehead temperature:
9
7
System Setting
System Setting
The temperature of a healthy person is affected by various factors:
the person’s individual metabolism, their age(body temperature is
higher in babies and toddlers and decreases with age. Greater
temperature fluctuations occur faster and more often in children,
e.g. due to growth spurts), their clothing, the ambient temperature,
the time of day(body temperature is lower in the morning and
increases throughout the day towards evening), the preceding
physical and, to a lesser extent, mental activity.
The temperature varies depending on the part of the body where the
measurement is taken. The difference can be between 0.2(0.4)
and 1(1.8) for a healthy person.
The normal temperature ranges are as follows:
• On the forehead: 35.8(96.4) to 37.6(99.7) , measured
with a forehead thermometer
• In the ear: 36.0(96.8) to 37.8(100.0) , measured with an
ear thermometer
• In the mouth: 36.0(96.8) to 37.4(99.3) , measured with
a conventional thermometer
In order to track temperature change, always take the measurements
in the same part of the body.
Body Temperature
Set the year
Set the month
.
Set the date
Press and release the S BUTTON to advance
one year until the correct year appears.
After the year is set, press M BUTTON, the Month
figure is flashing automatically.
Press and release the S BUTTON to advance
one month until the correct month appears.
After the month is set, press M BUTTON, the Date
figure is flashing automatically.
Press and release the S BUTTON to advance
one day until the correct day appears.
After the day is set, press M BUTTON, the Hour
figure will appear.
Set the minute
Press and release the S BUTTON to advance
one minute until the correct minute appears.
Set the hour
Press and release the S BUTTON to advance
one hour until the correct hour appears.
After the hour is set, press M BUTTON, the
Minute figure is flashing automatically.
5. , press M BUTTON t
Press and release S BUTTON to set
the Bluetooth function on or off(See Figure3).After the Bluetooth
function is set, press M BUTTON to exit system setting mode.
After the minute is set o enter into the
Bluetooth control mode.