Owner's Manual

17
15
16
Temperature Taking Hints
1. The Memory Mode can be accessed ether in ear mode, forehead
mode or object mode:
When the thermometer has been turned on
last measured temperature or finished testing, press and release
the M BUTTON, then the recent memory appears on the display.
2. The thermometer will automatically memorize the last 30
temperature readings.
Each time the M BUTTON
is pressed, the memory number adds one and shown on the screen ,
After releasing the M BUTTON, the screen shows another memory.
The number 1 reflects the most recent reading, while the number
30 reveals the oldest reading stored in memory.(See Figure 9)
3.
4. The user can press the BUTTON or the
button on the left to take new measurements.
and followed by the
Each memory also records the
measurement date/time/mode icon.
In the memory mode,
The thermometer will transfer all the memories to your mobile
phone via Bluetoothafter entering the memory mode for the
first time.
Temperature Taking Hints
To ensure that the reading always reflects the body temperature
accurately, you need to take account of the following factors which
may affect an accurate reading.
1. It is important to know each individual's normal temperature
when they are well. This is the only way to accurately diagnose
a fever. To determine normal temperature, take multiple readings
when healthy. Re-measure with a standard digital thermometer
for confirmation.
2. The probe window of the thermometer is the most delicate part
of the device. Do not touch the probe window. The accuracy of
the reading may be affected if the probe window is damaged or
dirty.
.
Holding a hand on the forehead for any length of time will affect
the temperature reading.
3
bathing, showering, shampooing and hair drying before/while
taking the measurement. In these cases, wait 20 minutes prior to
taking a temperature.
4.
Users should not drink, eat, or be physically active such as
5. Do not take temperature over scar tissue, open sores or abrasions.
6. Don't take a measurement while or immediately after nursing a
baby.
7. Do not use this thermometer outdoors.
8. Do not take temperatures with this thermometer near places that
are very hot, such as fireplaces and stoves.
9. If the thermometer is stored in a significantly different
environment than testing location, place it in the testing
location for approximately 30 minutes prior to use.
18
Memory Mode
After measurement:
1. Power off: Device will automatically shut off if left idle for
more than 1 minute to extend battery life.
2. Clean the probe after each use to ensure an accurate reading and
avoid cross contamination.
(See the section of Care and Cleaning for details.)
BackLight:
unit is ready for measurement and a measurement is completed.
The backlight design is to the benefit of reading in the night .
The display will only be lighted BLUE for 3 seconds when the
Temperature indicator:
In Ear/Forehead mode:
1. If the temperature reading is below 38.0 100.4 , the light bar
above the button will be green.
2. If the temperature reading is 38.0 100.4 or above, the light
bar above the button will be red.
℃( ℉)
℃( ℉)
Illustration For Use
Figure 9
Data Transmission:
Blouetooth after finishing the measurement or entering
the memory mode for the first time.
The thermoter will transfer all the memories to your phone via