Owner's Manual

Illustration For Use Illustration For Use
7
Illustration For Use
13
14
To measure object temperature:
1.
the object temperature after hearing two beep sounds.(see figure 5)
2. Aim the thermometer at the center of the object you want to
measure with a distance
e temperature on the
display.
4. Press and hold Test Button to turn off.
Press the Test Button to turn on the thermometer, you can take
less than 5cm.
3. Press the Test Button and then read th
Figure 5
How to change the forehead mode and object mode:
You can press and hold Setting Button to switch the mode between
Forehead mode and Object mode.
After measurement:
1. Power off: Device will automatically shut off if left idle for
more than 1 minute to extend battery life.
2. Clean the probe after each use to ensure an accurate reading and
avoid cross contamination.
(See the section of Care and Cleaning for details.)
BackLight:
In Forehead mode:
1. The display will be lighted GREEN for 3 seconds with a happy
face when the unit is ready for measurement and a measurement
is completed with a reading less than 37.3 (99.1 ).
2. The display will be lighted YELLOW for 3 seconds with a happy
face when a measurement is completed with a reading less than
37.8℃(100.0 ).
3. The display will be lighted RED for 3 seconds with a bad face
when a measurement is completed with a reading equal to or higher
than 37.8℃(100.0 ).
In Object mode:
The display will only be lighted GREEN for 3 seconds when the
unit is ready for measurement and a measurement is completed.
℃ ℉
℉
℉
1. Press the Test Button, The display is activated to show all
segments.
Note: Do not remove the thermometer from the forehead before
hearing .
3. Read the temperature on the display.
4. Press and hold Test Button to turn off.
After self-checking Figure 2 appears on the display
screen with voice, so you can start a new measurement.
2. Aim the thermometer at the center of the forehead with a distance
less than 5cm (See figure 3) and then press the Test Button.
voice
Note2:If the object to be tested is too far from the probe, a
prompt will appear(See figure 4).
To measure forehead temperature:
Figure 3Figure 2
Figure 4
12
11
Bluetooth requirements
The thermometer requires a bluetooth device with:
. Bluetooth 4.0 or later
. Android 6.0 or later
. IOS 8.0 or later
And works with:
. iphone , iPod, iPad
. Android Phones and Tablets
Using for the first time
1. Download the "JoyHeath" App from Website or APP Store (Such
as Apple Store).
2.Open the App on your phone or tablet. If requested, you should
enable Bluetooth on your device. You can enable Bluetooth under
the Settings menu on your smart phone or tablet.
3. Create a new user login, or login with your existing user name and
password.
4. Selection device “Thermometer”.
Illustration For Use