Control Center 240C User Guide
welcome Power / Standby Press to turn the Control Center power On and Off. The Power / Standby LED will illuminate green when the power is on and red when the unit is in standby mode Thank you for purchasing the JOYTECH Control Center 240C. Before connecting the Control Center, please familiarize yourself thoroughly with this User Guide so that you fully understand the setup procedure and functions of the product.
remote control which cable do I use? You can page through each Input Channel by pressing the Select Button on the front panel of the Control Center. Alternatively you can select each Input Channel by using the Directional or Numerical Buttons on the Remote Control. Depending on the type of output available from your AV device, use the most suitable cable connection from the 'Input Connection Table' below. Note: The Control Center is supplied with a standard Cable Pack.
audible bleep typical setup steps The Control Center features an audible bleep for confirming selection of each Input Channel. The sound can be toggled ON and OFF by pressing the SET button for 2 seconds until the icon appears on the display. Then use the + and - buttons to select either ON or OFF. 1) Connect the DC Power Adapter to the DC 12V IN located on the rear panel of the Control Center.
troubleshooting caution The Control Center fails to turn on: • Avoid placing this product near extreme temperatures or humidity. • Ensure that the DC Power Adapter is connected correctly and that the power is switched on. • Do not submerse or allow this product to come into contact with water. Use in dry locations only.
warranty When you purchase from JOYTECH, you purchase quality. JOYTECH offers a Two (2) year replacement warranty on this product. JOYTECH warrants to the original consumer purchaser that this product is free from defects in either material or workmanship. If a defect covered by this warranty occurs, JOYTECH, at its option, will repair or replace the product at no charge. JOYTECH products are tested to withstand normal wear and tear, but are not indestructible and can be damaged if misused.