User manual Radio TS2 2 2 channels Handles 2 channels Aux 2.4GHz Receiver 6 channels

Turn on the receiver power and
note the receiver LED will
illuminate a solid red. This
indicates it has successful paired
with the transmitter.
Check all controls are working as
they should do. Move both sticks
to check for correct movement. If
the Aux 4 dial and Aux 3 channels
are connected test these as well
for correct operation.
To reverse CH1, power off the Tx.
Hold the trim on the right gimbal to
the right and turn the TX power
back on. Keep holding the over
until the green LED goes solid.
Release the trim button and check
for correct operation.
To reverse the servo back again
just repeat the process.
Servo Revers - The ability to reverse CH1 and CH2 servo directions.
LED
To reverse CH2, power off the Tx.
Hold the trim on the left gimbal up
and turn the TX power back on.
Keep holding the trim up until the
green LED goes solid. Release
the trim button and check for
correct operation.
To reverse the servo back again
just repeat the process.
3