User's Manual

ManualsBrandsJR Auto Performance ManualsElectronicsMG Flasher Enet Wifi

MHD OBD2 Flasher Wifi Enet Module User Manual

Overview

MHD OBD2 Wifi Flasher was specially

developed and designed to operate the

Ethernet OBD2 diagnostic and coding

features via wired J2534 port and

wireless via an embedded module based

on the universal serial interface network

standard,built-in TCP / IP protocol stack,

enabling the user serial port, Ethernet,

wireless network (wifi) interface

between the conversions. the

traditional serial devices do not demand

to change any configuration, data can be

transmitted through the Internet

network. Provide a quick solution for the user’s serial devices to transfer data via Ethernet

Features

• 2.4GHz 802.11b/g/n,compatible

• Support IEEE 802.3、IEEE 802.3u

• WiFi Client/AP/Router Mode

• Support wps/wds

• The range of baudrate: 1200~500000bps

• Support transparent transmission mode

• Support multiple security authenti-cation mechanisms:

WEP64/WEP128/ TKIP/ AES

WEP/WPA-PSK/WPA2-PSK

• Support wireless roam

• Support multiple network protocols:

PPPOE/TCP/UDP/DDDNS /DHCP/DNS/HTTP/Firewre

• Support AT+ instruction set

• Support two config methods:Serial/WEB

• Device Dimensions 87*47*26mm

Summary of content (6 pages)

PAGE 1
MHD OBD2 Flasher Wifi Enet Module User Manual Overview MHD OBD2 Wifi Flasher was specially developed and designed to operate the Ethernet OBD2 diagnostic and coding features via wired J2534 port and wireless via an embedded module based on the universal serial interface network standard,built-in TCP / IP protocol stack, enabling the user serial port, Ethernet, wireless network (wifi) interface between the conversions.
PAGE 2
MHD OBD2 Flasher Wifi Enet Module User Manual Applications Ethernet OBDII WiFi Diagnose Specifications The parameters are defined here.
PAGE 3
MHD OBD2 Flasher Wifi Enet Module User Manual Wi-Fi Module Pin Assignment Electrical Characteristics 3
PAGE 4
MHD OBD2 Flasher Wifi Enet Module User Manual Operation Guidelines to work with car OBDII Step 1: Ignition ON, plug the MHD OBDII wifi flasher to the OBD2 diagnostic port Step 2: Search the Wifi ISID started with MHD_XXXX from laptop wifi and access with the password which sated at the back side of the module. Step 3: Successfully connected and operated as user demanded via OBD2 diagnostic port. Step 4: Administration panel setup for administrators only.
PAGE 5
MHD OBD2 Flasher Wifi Enet Module User Manual Appendix Disclaimers The contents of this document are subject to change without notice. Autosvs Technology reserves the right to make changes, without notice, in the products, including circuits and/or software, described or contained therein. Information contained in this document regarding device applications and the like is intended through suggestion only and may be superseded by updates.
PAGE 6
MHD OBD2 Flasher Wifi Enet Module User Manual FCC Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.