Operation Manual

4242

Assigning Channels

Using the scroll bar, move the cursor to the master channel. Press scroll bar

down to activate selection. Roll the scroll bar to select the desired channel.

Repeat this process to select the slave channel.

Origin Mixing

When origin mixing is activated any dual rate, exponential or other modifier

applied to the master channel is ignored on the slave channel. Therefore the

same dual rate, etc, modifiers are not present on the slave channel when a

command is inputted, they are only present on the master channel.

Assigning Mix Value

Using the scroll bar position the cursor over POS0 and click. Move the master

channel to highlight either the top or bottom figure. Increase or decrease the

mix value by rolling the scroll bar. Use the CLR key to reset the mix value to

zero. Complete the input by clicking the scroll bar. When activating the mix

with a switch, different mix values may be input for both switch position 0 and

switch position 1.

Establishing Offset

The purpose of the mixing offset is to redefine the neutral position of the

slave channel. Any desired position may be set for the offset reference point.

Position the cursor over Offset and click. Roll the scroll bar to input a value, in

steps of 2, between –170 and +170.

Operating with a switch

Position the cursor over the required switch and click to enable that switch.

The dark square moves to the top position (POS1) as a confirmation. More

than one switch may be selected if required.

Activation by Throttle Stick Position

Click the scroll bar with THRO STK selected. Roll the scroll bar to select a

throttle stick activation position between 0% and 100% or to inhibit (INH).

Note that the stick resolution has 200 steps so that two clicks of the scroll bar

are required to change the percentage displayed.

Failsafe

The failsafe/hold function is only available with PCM modulation. If you

have selected PPM modulation, the fail-safe screen will not appear.

Z-PCM modulation mode.

All channels can be HOLD or can take a pre-selected position. Three fail-safe

time delays are available. Select your chosen delay (0.2, 0.5 or 1.0 second) by

using the scroll bar to select the desired setting. For a pre-selected position

move the transmitter controls to the desired fail-safe position (throttle stick

low!) and store the settings by pressing the CLEAR key. A beep will sound to

confirm that the fail-safe positions have been stored.