Operation Manual

4444

4. Switch the master transmitter ON. Do not switch on the slave

transmitter; it is only necessary to have the master transmitter switched ON.

5. Push the trainer switch to transfer control to the slave. Release the switch

and control automatically reverts to the master transmitter.

Normal Trainer System

In this mode, all functions are switched from the master to the slave using the

trainer switch. No function setup is necessary to activate this system. Be sure

the slave transmitter’s servo reversing, dual rates, end point adjustment and

trims are identical to the master. This may be checked very easily by pulling

the trainer switch. If the control surfaces move, adjust the slave transmitter

until the trainer switch can be activated without a change to the control surface

position.

Programmable Trainer Function (P.T.F.)

In this mode, the master may assign functions one at a time to make learning

to fly easier for the student. For example, the master may assign the slave

rudder and elevator only. Thus, when the trainer switch is operated, the slave

has control of rudder and elevator only, while the master retains control of

throttle and aileron. Releasing the trainer switch returns all control to the

master transmitter. Be sure to reset the slave transmitter to its defaults by

using the reset function. All servo reversing, pitch and throttle curves etc. will

be taken from the master transmitter.

Use the scroll bar to rotate around the channels and toggle between master

and slave.

Note that when all channels are set to master, the trainer system becomes

NORNAL as indicated by the “NORMAL T.” on the screen.