Operation Manual

7
77
7
Modulation
The Modulation Selection Function enables your PCM9X to transmit to all JR
receiver types. You can select from either S-PCM or Z-PCM mode, depending
on the Central Processing Unit within your receiver, or from PPM (Pulse
Position Modulation—FM).
Caution: After making modulation changes, you must press the scroll bar to accept the new
modulation type. If the Tx power switch is turned OFF before this procedure, the modulation
change will not be saved.
Data Transfer
This function is used to transfer all existing memorised data for a model from
one PCM9X transmitter to another PCM9X transmitter. Use the scroll bar to
select the model to be transferred and activate by pressing the CLR key. To
avoid the loss of important data, re-confirm model names when transferring.
Caution: Please use special caution when copy function is activated as existing data is
replaced with new data.
Caution: When the battery alarm is activated (battery low), the copy function is not
operational.
Transfer Procedure
1. Select the model number to be transferred (transmitting mode side) through
the model select function.
2. Both transmitters: With the power switches OFF, press and hold the ENT
button while inserting the trainer cord into the DSC jack of the transmitter.
3. Both transmitters: Select the Transfer Function by rotating the scroll bar,
then press the scroll bar to enter the Transfer Function.
4. Receiving mode transmitter (Tx to be programmed): Rotate the scroll bar to
highlight the "Transmit" icon. Press the bar and the icon will change to
"Receive". Rotate the scroll bar to highlight the Model Number icon. Press the
bar and the icon will change to a box showing the available model numbers.
Select the receiving model number by rotating and pressing the scroll bar.
Next, press the CLR key to activate the receiving stand-by mode.