Installation Instructions

ManualsBrandsJS International ManualsDecorative AccentsJSI 30"W x 36"H White Framed Mirror

Vanity Cabinet

Assembly Instructions

This assembly instruction applies to V

DW-V3021D-R and VDW-V3021D-L

485 Commerce Dr.

Fall River, MA 02720

Parts included:

Cabinet Items

Qty

A Face Frame with Door

1 x

Side Panel

(Left and Right)

2 x

C Bottom Panel

1 x

D Back Panel

1 x

E Toe Kick

1 x

F Drawer Front

2 x

Drawer rails

(left and right)

2 x

Tools needed for assembly:

Drawer Items

Qty

Drawer rail

Holder

4 x

I Drawer Bottom

2 x

J Drawer Sides

4 x

K Drawer back

2 x

½” Flat Head

Screws

4 x

1 3/8 Drawer

Bolt / Cylinder

8 x

x 8

1/2'' Drawer

Rail Screws

20 x

Flat screwdriver

Philips screwdriver

Summary of content (5 pages)

PAGE 1
485 Commerce Dr.
PAGE 2
Step #1: Check and count the items in the box before your installation. If you are short any pieces, stop and call the supplier. Otherwise, follow the steps below. Step #2: Put the face frame (A) face down on a flat soft working surface (Figure 1). A Figure 1 Step #3: Install side panels (Figure 2): insert right and left side panels (B) into the grooves of face frame (A) and align the cam lock connectors.
PAGE 3
Step #4: Install the bottom panel (Figure 4): gently spread side panels and insert bottom panel (C) into the grooves of side panels (B) until it touches the face frame (A). B B A Figure 4 Step #5: Install the back panel and toe kick (Figure 5): put the back panel (D) at rear of side panels (B). Align it with the top of the side panels and lock each cam lock. Install the toe kick (E) by locking the cam locks at both ends.
PAGE 4
Step #7: Drawer assembly: place the drawer-face (F) face down on a flat soft working surface. Insert the screw cylinders (M) into the outer holes on the back of the drawer face (F) and drawer back (K) (Figure 7). M F K Figure 7 Step #8: Align the two drawer sides (J) with the drawer head and insert bolts (M) through the holes on the side panels into screw cylinders (Figure 8). J J F Figure 8 K Step #9: Slide drawer bottom (I) into the grooves of drawer sides (J).
PAGE 5
Step #10: To install the drawer rails, first separate inner rail from outer rail by pulling the drawer glide to the open position. Then push on the black plastic locking mechanism. Pull the inner and outer rails apart (Figure 10) Figure 10 Step #11: Use two 1/2” round head screws (N) to screw the inner rail to bottom side of drawer sides (Figure 11). Figure 11 Step # 12: Install outer rail to the cabinet frame by pushing the rails into the drawer rail holder.