Use and Care Manual

JSG Oceana vessels have a standard 1 3/4” hole which requires a 1 1/4” drain.
Recommended installation of a JSG Oceana vessel:
*Drill a hole in your countertop slightly larger than the width of your drain
(no less than 1 3/8” and no larger than 1 1/2”)
 Place a thin rubber washer or bead of
silicone between vessel and countertop as
a buffer (shown at left). If a rubber
washer is used you may also apply an
additional layer of clear caulking or
epoxy for added stability.
 Apply plumber’s putty under rim of drain
and place into sink. Drain will go through
vessel and hole in countertop.
 Tighten drain underneath by hand only.
DO NOT OVERTIGHTEN.
 If drain does not have enough threads to
tighten completely up to countertop,
purchase a piece of PVC pipe to make up
the difference. Use two rubber washers to
seal the PVC pipe and prevent leakage.
(PVC pipe can also be used if you
purchase a drain with an overflow hole.)
215 North Fourth Street, Jeannette, PA 15644
Ph: 724.523.5567 Fx: 724.523.0123
www.jsgoceana.com
PVC
Pipe
Rubber
washer
Rubber
washer