Use and Care Manual

Apply continuous bead of quality

sealant evenly to the top of sink flange

Check alignment of sink again and

tighten fasteners to secure sink

UNDERMOUNT STONE VANITY

INSTALLATION GUIDE

Step 1:

Position stone top upside down and place the sink

over the cutout

Apply bead of quality sealant evenly along the top

of the vanity

Apply silicone sealant evenly along

the bottom of backsplash and wall

Finally, place the bottom side of back splash with sealant

onto the countertop and check alignment of backsplash.

Adjust the leg levelers as needed

Step 3:

Step 5:

Step 2:

Step 4:

Step 6:

Caution: Read all instructions carefully before starting the installation. Sink style, shape, cutout on top and vanity

may vary from the pictures below. For instructional purposes only.

INSTALLATION INSTRUCTIONS

PAGE 1
UNDERMOUNT STONE VANITY INSTALLATION GUIDE INSTALLATION INSTRUCTIONS Caution: Read all instructions carefully before starting the installation. Sink style, shape, cutout on top and vanity may vary from the pictures below. For instructional purposes only.
PAGE 2
IMPORTANT CONSUMER INFORMATION CARE AND CLEANING For best results in caring for your stone top, we suggest: • Always wipe off spills immediately. • Seal the stone top regularly with a good quality stone sealer. • Never use strong / abrasive cleaner. Always test your cleaning solution on unnoticeable areas before applying to the entire surface. • Wipe surfaces clean, immediately after applying cleaner. • Do not allow cleaner to sit or soak.