Datasheet

Insulation stop

Flap locator

OPERATION INSTRUCTIONS

1. Open flap locator and

insert contact up to stop.

2. Close flap locator.

5. Close handtool

until the ratchet

releases.

6. Open flap locator

and carefully

remove the wire.

3. Close handtool

until first ratchet.

4. Insert wire up

to stop.

DWG: JUKCT-024-02-00

PAGE 1
. DWG: JUKCT-024-02-00 OPERATION INSTRUCTIONS 1. Open flap locator and insert contact up to stop. Insulation stop 2. Close flap locator. 2. 3. Close handtool until first ratchet. 4. Insert wire up to stop. Flap locator 3. 5. Close handtool until the ratchet releases. 6. Open flap locator and carefully remove the wire.
PAGE 2
193 JST 64 50 WC-JWPF JST DWG: JUKCT-024-01-00 Hand crimping tool Type: WC-JWPF Features Parallel action operation Ratchet release Easy readjustment of load Contact locator with insulation-stop Precisely ground profiles Ergonomic soft grips colour: green Fully recyclable Applicable terminal: ( )WPT-001T-0.25 ( )WPR-001T-0.25 Cross section range: Profile 1: 26 AWG Profile 2: 22 AWG Profile 3: 24 AWG Crimp height specification 26 AWG - 0.80mm 24 AWG - 0.82mm 22 AWG - 0.