User's Manual

Issue 2, July 2014
CONNECT CAMERA AND MOBILE DEVICE
1. From your device’s Settings, go to WiFi. Select the AppCam 25HD to connect your device
to it. The camera listing will be HD-XXXXXX where XXXXXX are the last 6 digits on the
camera label. Enter the default password, 12345678.
2. When the device is connected to the camera, launch the app
and tap the Add New System icon.
3. The System Information screen displays. Name the camera and tap Search..
4. The Search in LAN results box displays. The camera’s DID
should display. Tap the DID number.
5. The System Information screen displays again. This time, enter the security code
(123456); tap Save. Tap YES, then NO at the next prompts.
6. The Globe screen displays. Tap the Globe to access the AppCam 25HD video.
CONNECT CAMERA TO WIFI ROUTER
1. Tap the Back icon, the System icon, and then the
System Settings icon. The System Information
screen displays
2. Tap Advanced. Enter the Admin password (123456).
3. Scroll to WiFi on the Advanced Settings list. Tap
Manage WiFi Network. Select your router from the
drop-down list and enter your router’s password.
Tap Connect.
Your camera will reboot and reconnect to the router.
Wait until the camera’s LEDs return to the steady on
state to continue.
4. The Camera screen indicates that it is disconnected.
Tap the System icon and then the Refresh icon. The
camera refreshes and reconnects to the router you
chose. The LEDs should be both on steady and app
displays a photo of the video image.
PLACING THE APPCAM 25HD
Mount the AppCam 25HD Base
1. Hold the base of the camera stand where you
want to mount it and mark the
location of the screw holes.
2. Use the included screws and
anchors to attach the base to the
wall or ceiling. You can also screw
the base into a flat surface such as a
tabletop if needed.
3. Before attaching the camera, tug
gently on the stand to make sure it
is securely in place.
Aach the Camera - AppCam 25HD
1. For each AppCam 25HD, attach the
camera bracket to the mounting
screw. You can attach the stand to the
top or the bottom of the AppCam
25HD as needed. Tighten it a few
turns, then turn the AppCam 25HD to
face the direction you want.
2. Tighten the camera brace up against
the AppCam 25HD to secure it into
place.
3. Unlock the mounting post by turning
the wingnut to the left a few turns.
4. Set the mounting post to the correct
angle, then tighten the wingnut until
the post is locked into place.
5. After the AppCam 25HD is installed,
reconnect power.
SET TIME ZONE/DAYLIGHT SAVINGS TIME
It is important to set the correct time zone and daylight savings time indication on your camera to
ensure correct date/time stamp on the video files.
1. Access the Advanced Settings list (see Connect Camera to Internet, described previously.
2. From the Advancd Settings list, scroll to Time Zone.
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.