User's Manual

Model No.: CCD-640
2.4GHz Wireless Camera Observation System
with remote control
8. 1.
Contents
6.
7.
7.
8.
Troubleshooting
8.
1.
3.
4.
5.
Safety and Hazard Notices
Technical Data
Maintenance
FCC/CE WARNING
3.Parts Included in This System
System Installation
Installing the Camera
Installing the Receiver
Safety and Hazard Notices
Damages caused by non-compliance with this operating manual lead
to the expiration of the warranty! We will not assume any liability for
subsequent damages! We will not assume any liability for damages to
items or persons caused by improper handling or non-compliance with
the safety notices! Any warranty claim will be null and void in such cases.
• This product has left the factory in perfectly safety condition. In order to maintain this status
and ensure safe operation, the user has to observe the safety notices and warnings
("Attention!" and "Notice!") contained in this operating manual.
Other repairs as described above may only be performed by an
authorised workshop.
Troubleshooting
With this camera system, you have purchased a product that reflects the latest state of
technology and is safe to operate.Still there might be problems or malfunctions. At this point,
we want to tell you how to easily remedy possible malfunctions yourself.
Observe the safety notices under all circumstances!
Error Possible cause
No image and
no sound
• Camera or receiver are not supplied with electricity.
• Is the power pack plugged in correctly.
• The distance between the camera and receiver is too far.
The image/sound is.
distorted
• The range of the system was exceeded. Shorten the distance.
• There is a strong interference source (e.g. electric engine, walkie-talkie,
etc.) nearby.
• The distance between the camera and the receiver is too short;
this may over steer the receiver.Extend the distance.
• The supply voltage is too low
Flickering/running
image
• Strong spotlight in the cover range of the camera.
Normal sound,
image is too light
or dark.
White image only
on the monitor.
• Surveillance monitor (TV) is adjusted wrongly (readjust contrast and brightness).
• Strong spotlight in the cover range of the camera.
• The surveillance monitor (TV) is not correctly adjusted ( brightness controller).
Disposal
If the camera system no longer functions respectively can no longer be repaired, it must be
disposed of according to the valid statutory regulations.
Disposal of spent batteries / accumulators
You are required by law (Battery Ordinance)to return all spent batteries
and accumulators. Disposing of spent batteries/accumulators in the
household waste is prohibited! Batteries / accumulators that contain
hazardous substances are marked with the symbols on the side.
These symbols indicate that it is prohibited to dispose of these batteries/
accumulators in the household waste. The abbreviations for the respective
heavy metal are: Cd= cadmium,Hg= mercury, Pb= lead. You can return
spent batteries respectively accumulators that can no longer be charged
free of charge to the collection points in your community,
our outlets or everywhere else where batteries or accumulators are sold.
You thus fulfill the legal requirements and contribute to the protection of our environment!