User's Manual

JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K Page 18
Pager Operation
Prior to the initial use of the system, place all CommPass pagers in the
CommPass Charger (Fig. 13a) for a minimum of 12 hours to fully charge the
rechargeable battery pack. This action will also initialize the pagers, which are
shipped in “sleep mode.” When not in use, CommPass pagers should always be
stored in the charger. When placed in the charger, CommPass pagers will not
respond to transmissions from the master transmitter.
Fig. 13a – CommPass Charger Fig. 13b – Heartbeat
Upon removal from the charger, the CommPass pager will respond with a short
demo page, followed by the “heartbeat” indicator light (backlit pager number at
base of pager, Fig. 13b) which will flash approximately every 3 seconds
indicating that the pager is awake and ready to receive pages. This initial demo
page also allows preview of the normal alert to the guest, patient, customer, etc.
CommPass Charger
CommPass pagers are stored in the Charger (Fig. 13a) for convenient usage.
The pager receiver is deactivated when placed in the charger (i.e. it will not
respond if paged from the transmitter.)
The CommPass charger efficiently stores 20 CommPass pagers in a minimum
space. The CommPass charger can be daisy chained to a maximum of three (3)
chargers (supporting up to 60 pagers) on a single specialized power supply also
available from JTECH. A small green power indicator light is visible in the center
of the charger base between the pager stacks, which will illuminate when power
is properly supplied to the charger.