User's Manual

JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K Page 26
Appendix A – Transmitter Function Menu
Function Menu Descriptions
The following table lists the special functions available from the transmitter
keypad with the Desktop Transmitters. (Many functions are accessible from the
telephone interconnect although some are not.) From the transmitter keypad,
press the * key to scroll down through the features menu. Follow the instructions
shown below to activate a special feature. To return to the paging mode, scroll to
the end of the special function menu and the unit will automatically return to the
paging mode. In summary: Press * to scroll down the menu, Press # to enter a
function, Press 0 to scroll up through functions if not past the ‘Active Groups’.
Function Description
Replace Pager
Scroll Down *
Scroll Up 0
Enter Function #
(Return a Pager to
the original Pager
ID)
Logically replaces pagers. Input the old pager number (1 to 4
digits), #, the new pager number (1 to 4 digits), #, and the kind
of pager (2 pages of options, press # to get to the second
page. Pager type selection is done by entering a 1, 2, 3, or 4
from the screen; touch # to scroll to screen 2). To repeat the
replace pager operation, press # again. Up to 500 old pagers
may be replaced. After the Replace Pager entry, the new
pager will be paged when the old pager number is entered.
To remove an entry in the replace table and return the pager to
its original pager ID, enter the original pager number as the old
pager number and enter zero for the new pager number. A
confirmation message will say that the Original pager number
has been removed.
Display Pager
Scroll Down *
Scroll Up 0
Enter Function #
Displays all pagers that have been replaced. The # key takes
you forward to the next entry; zero takes you back to the
previous entry. Exit the function by pressing the * key at any
time.
Add Pager to
Dynamic Group
Scroll Down *
Scroll Up 0
Enter Function #
There are 99 Dynamic Groups that can be programmed. The
first 9 (1 – 9) are transmitted with any factory pre-programmed
groups with the same number. To build a group of pagers that
will be paged in rapid succession (Dynamic Group), press # at
this menu item. When asked ‘Which Group’, enter a one or
two digit group number. When asked ‘Which pager’ enter the
last pager on the group list (Dynamic groups are paged in the
reverse order of entry). The pager type must be selected by
entering 1, 2, 3, or 4, which identifies the pager as POC,
Glwstr, NUM, or ALP (alpha). Press # after this entry to enter
another pager in the same dynamic group. Press * when the
last entry has been made. Up to 500 pagers may be entered in
dynamic groups. Pagers entered in dynamic groups will be
replaced if they are entered in the replace pager table. As
Dynamic Groups are built, users should ideally create each
pager groups to consist of 10-12 pagers so that the
transmission period does not tie up the transmitter. Groups
can consist of a mixture of pager types. The transmitter cannot
be used for other pages while transmitting pages from the
dynamic group are being sent.