User's Manual

JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K Page 27
Function Description
Remove Pager from
Dynamic Group
Scroll Down *
Scroll Up 0
Enter Function #
Removes a pager from a dynamic group. When asked ‘Which
Group?’ enter a one or two digit dynamic group number and
press #. When asked ‘Which Pgr?’ enter the one to four digit
pager number to be removed from the specified Dynamic
Group and press #. The confirmation message will be
displayed “pager # out of group #”.
Display Members of
Dynamic Group
Scroll Down *
Scroll Up 0
Enter Function #
Displays the members of a specific Dynamic Group. When
asked ‘Which Group?’, enter a one or two digit Dynamic Group
Number. Pressing the # key displays the next member of the
group in the order that it will be transmitted. After the last entry
in the group has been displayed, pressing the # key will cause
the display to show ‘End of Group’. Press # to repeat for
another group. Press * to go back to the next function in the
main menu.
Display Active
Dynamic Groups
Scroll Down *
Scroll Up 0
Enter Function #
Displays the group numbers of dynamic groups that have
members. Press # to step to the next group number. At any
group, pressing 0 enters the ‘display members’ mode
explained above where the members of that group can be
displayed.
Turn Off All
RapidCall Vibe/Tone
pagers
Scroll Down *
Sends a page to turn every RapidCall vibe/tone pager off to
preserve the alkaline batteries. Press # to send the command.
The display and TX indicate the command is being sent.
(Alternately, this command can be sent by entering “9991#” on
the keypad at the enter pager screen or from the telephone.)
This feature also allows for a time delay (hours.) The factory
default is 0 hours for delay. If immediate shut down desired,
simply press # again to select. If a delay is required, press the
hour, e.g. 1, followed by the pound key. If a 1-hour delay is
used, it will be present the next time this OTA off prompt is
selected, and must be overridden by a 0 to select an
immediate shut down the next time the feature is used.
Turn Off All
RapidCall Numeric
pagers
Sends a page to turn every RapidCall Numeric pager off to
preserve the alkaline batteries. This command can be sent by
entering “9993#” on the keypad at the enter pager screen or
from the telephone. The display and TX indicate the command
is being sent.
Turn Off All Glowster
pagers
Place the pager onto the Charging Rack.