User's Manual

WIRELESS MICROPHONE SYSTEM
19
5-3 Body-pack Transmitter // PT-36BG2
(1) Press the SET buon to select between frequency /group/ sensitivity / RF outputs.
(depends on country)
1. Frequency adjusting
Press the UP or DOWN buon to adjust the seing of a menu.
1-1 Hold SET buon for 3 seconds to activate frequency.
1-2 Once you see ”MHz” blanking , you are ready to select your desired frequency
by using UP and DOWN buons.
1-3 Press the SET buon again to store your changes.
2. Group adjusting
2-1 Press“Set” buon for 3 seconds, the group (G) will ash. (Figure 6)
2-2 Presss“ Up ” or “ Down ”buon to select a desired group.
2-3 Press “Set” again and the Channel (CH) will ash.
2-4 Press “ Up” or “ Down” buon to select a desired channel.
2-5 Aer seing, press “Set” again to save the seing.
3. Sensitivity adjusting
3-1 Press the SET buon twice to select sensitivity. Lasting for 3 seconds at the rst
press, then 1 second for the second press, and the display appears .
3-2 Use UP and DOWN buons to adjust changes.
3-3 Finally press SET buon again to store your changes.
4. RF Outputs adjusting
4-1 Push the “Set” buon several times until the “rF Lo “ or “rF Hi” ashes.
4-2 en push “ Up ” to choose “Hi” for high transmiing power and push
“ Down ”to choose “Lo” for low transmiing power.
4-3 Selectable transmission power betwem 10mW & 50mW.
4-4 Push the “Set” again to save the seing.
22
22
23
24
23 24
Figure 6
3”