Installation Guide

Phoenix 1 Installation Guide
Juganu HQ
1 Yahadut Canada St., Or-Yehuda, Israel
Tel.: + 972-3-5310031
[e-mail]
WWW.JUGANU.COM
The Information provided herein is subject to change without prior notice by Juganu. Please
verify all details with Juganu. All values are typical values when measured under normal
laboratory conditions, and Juganu makes no warranties, expressed or implied, that such
performance will be obtained under end-use conditions.
JL-IG_Phoenix1 | Rev.03
14
9. Tighten the rear part of the gland to the front part of the gland.
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limi
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between radiator & your
body.