Installation Guide

Phoenix 1 Installation Guide
Juganu HQ
1 Yahadut Canada St., Or-Yehuda, Israel
Tel.: + 972-3-5310031
[e-mail]
WWW.JUGANU.COM
The Information provided herein is subject to change without prior notice by Juganu. Please
verify all details with Juganu. All values are typical values when measured under normal
laboratory conditions, and Juganu makes no warranties, expressed or implied, that such
performance will be obtained under end-use conditions.
JL-IG_Phoenix1 | Rev.03
3
Introduction
This guide shows how to install the Phoenix1 unit on a pole.
The mounting arm is supplied by Juganu and supports a 51-60 mm diameter pole adaptor.
Required Tools
 Metric Allen Key Hexagon Wrench Screwdriver Set
 Metric Open-end or combination wrench key
Notes
 The Phoenix1 unit can be installed on a vertical or horizontal pole.
 The mounting arm orientation can be aligned to +/-15°
Mounting arm
(supplied by Juganu)