OWNER’S MANUAL CQ SERIES SEQUENCED POWER CONTROL SYSTEM COVERS MODELS CQ-1520 , CQ-1 , CQ-2200 , CQ-3000 and CQ-PD1-4 TM TM TM TM TM OCTOBER 2013 File: 3176209DEN-001 Standard: UL508
DISCLAIMER Juice Goose shall under no circumstances be held responsible for any losses, damage, or injury resulting directly or indirectly from the use of a CQ Series device in a manner contrary to accepted safe operating methods or any instructions contained in this document. The user should determine prior to use whether this product is adequate, suitable and safe for the application intended.
CQ-SERIES SEQUENCED POWER CONTROL SYSTEM The Juice Goose CQ Series products are power distribution devices that will control AC power application to multiple pieces of equipment. The primary intent of the design of this equipment is to power rack mounted audio or video equipment with electric power current requirements of less than 15 amps, 20 amps or 30 amps depending on the CQ model being considered. All CQ Series products can be remote activated.
DETAIL SPECIFICATIONS DIMENSIONS (H x W x D inches) CQ 1520…………………………………………………….....….....………...1.72 x 19.00 x 7.00 CQ 1(Including 3 Gang Utility Box).............................................................4.50 x 6.50 x 3.75 CQ 2200 ................……………….......................……………………………5.50 x 6.40 x 3.75 CQ 3000.....................................................................................................9.00 x 6.00 x 4.00 CQ PD1-4.…..…………………………………………….....………………...32.00 x 3.50 x 2.
INSTALLATION CQ 1520 — Mount the CQ-1520 to a 19” wide rack with metal mounting rails, designed with 1.75” spacing. Use appropriate rack mounting hardware. Plug the power cord into a grounded outlet. Do not defeat the grounding feature of the CQ-1520 power cord. CQ 1, 2200, 3000 & CQ-PD1-4 - These products were designed to be installed only by qualified electrical technicians. Failure to follow correct installation techniques and instructions could result in equipment damage and/or personal injury.
labeled. Attach the front panel (containing the circuit board) to the back box using all seven screws. Gently pull excess cable length out of the box by tugging slightly on the cable from the outside of the box. Insert conduit into squeeze connector and tighten the connector to hold the conduit in place. CQ-PD1-4 - The CQ-PD1-4 has two slotted side brackets that can be relocated along the length of the chassis. Use only appropriate hardware (not included) and use four mounting holes to secure the device.
REMOTE SWITCH CONNECTION Although a Juice Goose CQ Series product can be remote controlled with a Juice Goose RC-5 accessory or another CQ device, it can also be remote activated with a simple contact closure using a switch or relay. The following instructions are provided to assist with this configuration. This information is also useful for assembling interface wiring going to and from the RJ type cable specified for the CQ system.
CQ Series Signal Cable Connectors Signal Input Signal Output 87654321 12345678 PIN ASSIGNMENTS The chart above shows assigned locations for each of the eight pins on the RJ45 connectors on the CQ Series Signal Input and Output. Note: although there are eight pins, only the middle six are being used. This information may be used to connect a latching contact, as per the diagram on the previous page. It also illustrates the reversed orientation of the connectors on each end of a CQ signal cable.
vices can be connected in a daisy chain fashion to operate as a power sequencing system. REMOTE CONTACT CLOSURE - As one option, to control the sequencing function, the Signal Input for the first CQ device can be connected to a contact closure (see Remote Switch Connection). Any latching switch or relay will work. Juice Goose recommends use of a double throw device in order to maintain one of two contact closures at all times.
IN CASE OF MALFUNCTION The Juice Goose CQ Series of products are ruggedly constructed and contain quality components. There are no user serviceable parts inside a CQ device. Unauthorized service will void all existing warranties and may result in equipment damage and personal injury. Should improper performance be observed consult the following guidelines for diagnosis. SYMPTOMS AND SOLUTIONS. (NOTE: References to LEDs and circuit breakers do not apply to the CQ-1 and CQ-PD1-4) 1. Unit will not turn on. a.
OTHER JUICE GOOSE PRODUCTS RACK MOUNTED POWER DISTRIBUTION - Nineteen inch horizontal power distribution with several optional levels of AC power protection AC LINE FILTRATION - The Juice Goose RX Series Hybrid Filter technology provides very high levels of protection against damaging power surges and high frequency interference on hot, neutral and ground.. All this is available at very attractive prices with the RX Series.
