Operation Instruction

12
Click , when the coordinates of head 1 become the coordinates employed in
. Set the values of heads 2 and 3 in relation to head 1 below, and
will change correspondingly; click OK to save the settings.
: “Needle rod up/down” key
，
Press the key to switch between upper position (the
highest
point of needle) and lower position (the lowest point of need).
:"Return" key
，
Press the key to return to the previous operation interface.
Display Instruction for Reference Setup Interface
Click in the main interface of processing to get into the reference point setup interface.
The template reference point can be set in this interface.
: Lifting function is mainly used for "rotary head" type machine, outputting IO
corresponding to the set parameters (P249). High and low level switch each other.
: As mentioned earlier (all foot pressing functions on the interface are the same)