Operation Instruction

28
Where accurate circle is needed, it is recommended that the distance between the first and second
points should be the diameter of circle; the third point should be in the perpendicular bisector of the
diameter line determined by the first and second points, and its distance from the diameter line should
be the radius of circle.
Curve Capture
Press ykien main interface of file capture, when the key background turns yellow, which
means the current segment capture is in curve mode as shown in the figure:
In the case of curve capture, up to 127 consecutive points can be handled, and the Bezier is
generated by the degree of arc of the neighboring 4 points. The capture point shall be as dense as
possible at the turning so as to achieve optimal curve effect. The capture of less than 3 points can
generate curve.
The absolute origin or the end point of previous capture segment is the first point of curve capture.
Press the key to move to desired position, press key to identify the capture point, and move for
several times to determine capture points; upon completion, press key to generate the curve.
Multiple Curves
In the case of file capture, if the current capture curve (except idle and straight line capture)
requires multiple sewing, it's necessary press key to get into multi-curve setup interface as
shown in the figure: