Operation Instruction

29
next capture.
: State ON/OFF.Determine whether multi-curve sewing is employed or not for
: Mode selection. There are two modes available for selection, i.e. internal
shrinkage and external expansion. Internal shrinkage means the offset shrinkage at designated spacing
based on capture graph; external expansion refers to the offset expansion at designated spacing based
on capture graph.
: Indicate the increased number of curves; the range of entry: 1~20.
: Indicate the distance between stitch threads; the range of entry: 0.1~20.0mm.
Select multiple sewing as needed, and set the offset distance and the number of offset layers.
Upon completion of the setup, press key to save current settings and go back to the main
interface of capture graph.
For instance: Set the state to "ON", the mode to "internal shrinkage", the number of layers to "5",
and the spacing to "3.0"; click "OK" and perform a "rectangle capture" to get the curve as shown below;
all the 5 rectangles inside are generated on a multi-curve basis.