Operation Instruction

33
There are 25 function codes:
：
Set the IO number to be output and its high and low levels; when the function code is
encountered, the corresponding IO outputs corresponding level.
：
Set the level for which the entered IO number should be detected. If the function code is
encountered, subsequent operations shall be performed when the corresponding IO is at high or low
level.
：
Set the delay time. The delay time that corresponds to the "single point" or "all
points"
function code.
：
Move directly to the set sub-origin position.
：
Return to the stop position after reset.
：
Upper pause function code; when this function code is encountered, the spindle stops
at upper stop position.
：
Lower pause function code; when this function code is encountered, the spindle
stops
at lower stop position.
：
"spindle speed" instruction.It changes the current working sewing speed temporarily.
：
The "idle speed" command temporarily changes the current working idle speed.
：
The "Recovery Speed" instruction restores the speed at which the preamble is
modified
by the "Spindle Speed" instruction to the working speed set by the interface.
：
Trim function code; when this function code is encountered, the thread is cut without
stopping the spindle.
：when this function code is encountered, the press frame goes up, while the spindle
stops at upper part.
：when this function code is encountered, the press frame goes down without spindle
stopping at upper part.