Operation Instruction

34
：
The "Z Axes speed" instruction temporarily changes the speed of Z axis.
：
"Rotate along the trajectory" command, "Cutting trajectory" is used for rotary cutting
of cutter, and "Sewing trajectory" is used for rotary sewing of machine head.
：
The "Rotation Enabler" command temporarily closes or turns on the "Rotation
along
the Track" function.
：
Detection of the current frame pressing state, when the frame pressing is lifting
state,
stop working and error "frame pressing is not pressed down".
：Absolutive motion function code; when this function code is encountered, XY
move absolutive to each other.
：
"Pressure foot height" command, temporarily changes the pressure foot height.
：
Cancel the next trimming operation.
：Motor thread clamp function code; the thread clamp strength when the function
code is encountered.
：Motor thread clamp function code; the thread clamp strength when the function
code is encountered.
：Knee start function code; when this function code is encountered, knee is started
：Knee speed function code; when this function code is encountered, the spindle
rotates at the function code speed.
：Knee end function code; when this function code is encountered, knee sewing
comes to an end while the sewing speed is restored.
Press the key to add function code as needed; choose "single point" or "all points" for adding
function code; select necessary instructions; set the corresponding requirements; click "Save" to add.
Alternatively, you can edit the graphs in capture graph interface, click to enter graph
editing interface, use to choose the graphs to be handled (the graphs turn blue when chosen),