Operation Instruction

63
: When adjusting the offset-free reference point, the offset reference point should be set first.
: According to the reference position, the reference-free offset position is automatically
calculated and set.
：
Restore key, the parameters set can be restored by the restore key before they are saved.
Introduction to Setting up Mechanical Parameters
Parameter
classificati
on
Parameter name Range Default Parameter meaning and remarks
Shaft
Angle
Setting
Feeding start angle 0-999 0
Feeding end angle 0-999 0
Trimming start angle 0-999 0
Trimming end angle 0-999 0
Surface line dial
angle
0-999 0