Operation Instruction

74
Test the corresponding output as needed.
For trimming, wiping and relaxation electromagnet outputs, one click corresponds to an on/off
cycle of equipment electromagnet; if the key is held, ON state will continue. Holding the key too
long may result in overheating induced damage to electromagnet.
For solenoid valve outputs such as press frame and press foot, one click corresponds to one
motion cycle of cylinder, and another click will return the cylinder to its initial state.
The OUT1, OUT2... function depends on specific device load, and some outputs are not used.
Lamps 1 and 2 are used to control "SYS" indicator lamp ON/OFF on screen, and correspond to
red and blue lamps, respectively.
When is clicked, it shows the message reading "In progress, please wait...", which
indicates a full output test is being performed; the prompt box will not be closed until the test is
completed.