Operation Instruction

89
Appendix II: Quick Start Guide
(1) Start the machine
Install the equipment and connect the power supply. Turn or press the power switch to start the
machine. Get into the main interface of processing as described in Section 2.2.1 after the logo
appears. Where bottom thread winding is needed, refer to Section 2.2.2.
(2) Set up processing file
Copy the .SLW processing file generated by the PC sewing editing software into the USB flash
disk; insert the USB flash disk into the USB interface of equipment; click ->
-> in the main interface of processing to get into "USB flash disk" interface, click the
name of the file to be processed to make it turn red, and click ctopy the file into memory.
Press -> to return to the main processing interface. Select the file to be
processed on the left, when the processing pattern can be previewed in the middle of interface.
If "file capture" function is used to create processing file, see Chapter IV.
(3) Place the template
Put the fabric to be processed into the prepared template, click , and click to make
press frame get into rising state. Place the template under press frame, and click so that
the press frame can go down and press the template
(4) Align with reference
See Section 2.2.4
(5) Start the processing
Press start button in the main interface of processing, and the machine will start the processing
based on pattern. Upon completion of processing, the system automatically returns to the reset
origin or other set points.
Note:
1. If the processing is not performed for the first time (it has been copied into memory for reference
alignment, and the automatic template recognition function has been enabled), only two steps will
be needed: Place the template -> Start the processing