Owner manual

Cleaning / repairing the unit

15. Cleaning / repairing the unit

Caution:

 Always turn off the unit and disconnect the mains cable from the power source

before cleaning the unit.

 Prevent humidity from entering into the circulator.

 Electrical connections and any other work must be performed by qualified

personnel only.

To maintain the full cooling performance, clean the condenser from

time to time.

 Switch off the unit, disconnect mains power cable.

 Hold the venting grid, pull out and remove.

 Clean the ribbed condenser with a vacuum cleaner.

 Replace the venting grid.

 Switch on the unit.

Cleaning:

For cleaning the bath tank and the immersed parts of the circulator, use

low surface tension water (e.g., soap suds).

Clean the outside of the unit using a wet cloth and low surface tension

water.

The circulator is designed for continuous operation under normal

conditions. Periodic maintenance is not required.

The tank should be filled only with a bath fluid recommended by

JULABO. To avoid contamination, it is essential to change the bath fluid

from time to time.

Repairs

Before asking for a service technician or returning a JULABO

instrument for repair, please contact an authorized JULABO service

station.

When returning the unit:

 Clean the unit in order to avoid any harm to the service personnel.

 Attach a short fault description.

 During transport the unit has to stand upright. Mark the packing

correspondingly.

 When returning a unit, take care of careful and adequate packing.

 JULABO is not responsible for damages that might occur from

insufficient packing.

JULABO reserves the right to carry out technical modifications with

repairs for providing improved performance of a unit.