User Manual

This device complies with Industry Canada’s license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
6.3.2 RF Exposure
All transmitters regulated by the Innovation, Science and Economic Development Canada (ISED) must
comply with RF exposure requirements listed in RSS-102 - Radio Frequency (RF) Exposure Compli-
ance of Radio communication Apparatus (All Frequency Bands).
This transmitter is restricted for use with a specific antenna tested in this application for certification,
and must not be co-located or operating in conjunction with any other antenna or transmitters, except
in accordance with Innovation, Science and Economic Development Canada multi-transmitter guide-
lines.
The installation of the transmitter must ensure that the antenna has a separation distance of at least
30 mm from all persons or compliance must be demonstrated according to the ISED SAR procedures.
6.4 Europe
The module is a Radio Equipment Directive (RED) assessed radio module that is CE marked and has
been manufactured and tested with the intention of being integrated into a final product.
The module has been tested to RED 2014/53/EU Essential Requirements for Health and Safety
(Article (3.1(a)), Electro Magnetic Compatibility (EMC) (Article 3.1(b)), and Radio (Article 3.2)
Blum 23.A00L83 RF Module Manual 1.0.2
Page 15 of 17