User Manual

23
5 Operation
5.6 Operation of the program controller
Normal display No program run in normal display, the controller controls to the selected setpoint.
Altering the
setpoint
From normal display:
h Change to setpoint input with
D
h Alter the present setpoint with I and D
(the value is accepted automatically)
Starting the
program
From normal display:
h Start program with
I
(the ramp symbol lights up!)
A delay time can be configured through the setup program. When the delay time has
elapsed, “
Strt” is shown in the lower display, and then the program is processed.
Canceling the
program
When the program is running:
h Cancel program with
I
Pausing the
program
When the program is running:
h Pause program with
X (press for more than 2 seconds)
(the lower display blinks!)
h Continue with
X (press for more than 2 seconds)
The program is canceled in the event of a power failure.
Additional program control functions via binary functions.
v Chapter 8.6 “Binary functions “binF””
Normal display
Program is running
Program pause
Altering the setpoint