User Manual

26
7 Commissioning
7.1 Getting started
✱ Mounting the instrument, See section 5 "Mounting", page 14.
✱ Installing the instrument, See section 4 "Electrical connection", page 11.
✱ Unlocking the instrument, See section 7.2 "Unlocking the instrument (code
entry)", page 27.
✱ Selecting the unit of the measured value, See section 7.4 "Selecting the unit
of the measured value (Uni.P)", page 28.
✱ Adjusting the output signal, See section 7.7 "Setting the output signal
(S.TyP)", page 32.
✱ Adjusting the scaling of the output signal (restricting the measuring range),
See section 7.8 "Setting scaling", page 33.
✱ Setting the switching function, See section 7.10 "Setting the switching
function (B.Fct)", page 37.
✱ Setting the switching point, See section 7.11 "Setting the switching point
(B.SP)", page 39.
This is a suggestion for configuring the instrument reliably in little
time.
By checking the setting options of this list before starting the
configuration, you can avoid timeouts during the configuration.