User Manual

7 Commissioning
32
7.6 Setting the filter time constant (damping) (DamP)
The filter time constant (damping) can be used to smooth the measured value.
Small filter time constant: the display is refreshed quickly.
Large filter time constant: Display refresh is slower.
The value is entered in seconds with two places after the decimal.
✱ Unlock the instrument, See section 7.2 "Unlocking the instrument (code
entry)", page 27.
✱ "Rotate" until the bottom line shows "Dam.P".
✱ "Press"
7.7 Setting the output signal (S.TyP)
✱ Unlock the instrument, See section 7.2 "Unlocking the instrument (code
entry)", page 27.
✱ "Rotate" until the bottom line shows "S.TyP".
✱ "Press"
Example
4.20A = output signal 4 ... 20 mA
0.20A = output signal 0 ... 20 mA
0.10U = output signal 0 ... 10 V