User Manual

Contents
7 Commissioning ....................................................................... 26
7.1 Getting started ...........................................................................................26
7.2 Unlocking the instrument (code entry) .......................................................27
7.3 Cancel operation ........................................................................................28
7.4 Selecting the unit of the measured value (Uni.P) .......................................28
7.5 Setting the zero point (offset) (Off.P) ..........................................................31
7.6 Setting the filter time constant (damping) (DamP) .....................................32
7.7 Setting the output signal (S.TyP) ................................................................32
7.8 Setting scaling ............................................................................................33
7.9 Setting the error signal (S.Err) ....................................................................36
7.10 Setting the switching function (B.Fct) ........................................................37
7.11 Setting the switching point (B.SP) .............................................................39
7.12 Setting the reset point (B.RSP) ..................................................................40
7.13 Setting the switching difference (hysteresis) (B.HYS) ................................40
7.14 Setting the switching delay (B.DLY) ...........................................................41
7.15 Setting the display alignment (D.Dir) ..........................................................41
7.16 Setting the display unit (D.Uni) ...................................................................42
7.17 Displaying the version of the operating device software (SW.Di) ..............43
7.18 Displaying the version of the signal stage software (SW.Si) ......................43
8 Calibration ............................................................................... 44
8.1 Setting the zero point (offset) .....................................................................44
9 Setup program ........................................................................ 45
9.1 Function .....................................................................................................45
9.2 Start the setup program .............................................................................46
10 Eliminating errors and faults .................................................. 48
10.1 Possible errors ...........................................................................................48
11 Instrument description ........................................................... 49
11.1 Technical data ..........................................................................................49