User Manual

25
5 Address tables
5.2 Setpoints
5.3 Controller parameters
0x005B LONG R/O Program run time (in seconds)
0x005D LONG R/O Residual program time (in seconds)
0x0061 LONG R/O Segment run time
0x0063 LONG R/O Residual segment time
0x0067 LONG R/O Timer run time, timer 1
0x0069 LONG R/O Timer run time, timer 2
0x006B LONG R/O Timer run time, timer 3
0x006D LONG R/O Timer run time, timer 4
Address Data type/
bit number
Access Signal designation
0x3100 FLOAT R/W Setpoint W1
0x3102 FLOAT R/W Setpoint W2
0x3104 FLOAT R/W Setpoint W3
0x3106 FLOAT R/W Setpoint W4
A
The setpoint limits will not be checked when setpoints are altered via the interface.
A
Write operations to these parameters result in them being saved to the EEPROM.
These memory chips only have a limited amount of write cycles
(about 10000), this is why this function can be switched off in the case of frequent
programming. The parameter values are then saved to the volatile memory (RAM)
only and are lost after a supply failure.
v Setup/Only Setup/Undocumented parameters/Bit parameters/
Set parameter 2
Address Data type/
bit number
Access Signal designation
0x3000 FLOAT R/W Parameter set 1: Pb1
0x3002 FLOAT R/W Parameter set 1: Pb2
0x3004 INT R/W Parameter set 1: dt
0x3005 INT R/W Parameter set 1: rt
0x3006 FLOAT R/W Parameter set 1: Cy1
0x3008 FLOAT R/W Parameter set 1: Cy2
0x300A FLOAT R/W Parameter set 1: db
0x300C FLOAT R/W Parameter set 1: HyS1
Address Data type/
bit number
Access Signal designation