User Manual

5 Address tables
26
5.4 Configuration
0x300E FLOAT R/W Parameter set 1: HyS2
0x3010 INT R/W Parameter set 1: tt
0x3011 INT R/W Parameter set 1: y0
0x3012 INT R/W Parameter set 1: y1
0x3013 INT R/W Parameter set 1: y2
0x3014 FLOAT R/W Parameter set 2: Pb1
0x3016 FLOAT R/W Parameter set 2: Pb2
0x3018 INT R/W Parameter set 2: dt
0x3019 INT R/W Parameter set 2: rt
0x301A FLOAT R/W Parameter set 2: Cy1
0x301C FLOAT R/W Parameter set 2: Cy2
0x301E FLOAT R/W Parameter set 2: db
0x3020 FLOAT R/W Parameter set 2: HyS1
0x3022 FLOAT R/W Parameter set 2: HyS2
0x3024 INT R/W Parameter set 2: tt
0x3025 INT R/W Parameter set 2: y0
0x3026 INT R/W Parameter set 2: y1
0x3027 INT R/W Parameter set 2: y2
A
Write operations to these parameters result in them being saved to the EEPROM.
These memory chips only have a limited amount of write cycles
(about 10000), this is why this function can be switched off in the case of frequent
programming. The parameter values are then saved to the volatile memory (RAM)
only and are lost after a supply failure.
v Setup/Only Setup/Undocumented parameters/Bit parameters/
Set parameter 2
Address Data type/
bit number
Access Signal designation
0x0077 FLOAT R/W Limit comparator 1, limit AL
0x0079 FLOAT R/W Limit comparator 1, switching differential
0x007B INT R/W Limit comparator 1, switch-on delay
0x007C INT R/W Limit comparator 1, switch-off delay
0x007D FLOAT R/W Limit comparator 2, limit AL
0x007F FLOAT R/W Limit comparator 2, switching differential
0x0081 INT R/W Limit comparator 2, switch-on delay
0x0082 INT R/W Limit comparator 2, switch-off delay
0x0083 FLOAT R/W Limit comparator 3, limit AL
0x0085 FLOAT R/W Limit comparator 3, switching differential
0x0087 INT R/W Limit comparator 3, switch-on delay
Address Data type/
bit number
Access Signal designation