User Manual

1 Introduction
6
1.2 Typographical conventions
1.2.1 Warning signs
The symbols for Danger and Caution are used in these operating
instructions under the following conditions:
1.2.2 Note signs
1.2.3 Representation
V
Danger This symbol is used when there may be danger to
personnel if the instructions are ignored or not followed
correctly.
*
Caution This symbol is used when there may be damage to
equipment or data if the instructions are ignored or not
followed correctly.
E
Caution This symbol is used where special care is required when
handling components liable to damage through
electrostatic discharge.
)
Note This symbol is used when your special attention is
drawn to a remark.
Ö
Reference This symbol refers to further information in other manuals,
chapters or sections.
abc
1
Footnote Footnotes are remarks that refer to specific points in the
text. Footnotes consist of two parts:
A marker in the text, and the footnote text.
The markers in the text are arranged as continuous
superscript numbers.
The footnote text (in smaller typeface) is placed at the
bottom of the page and starts with a number and a full
stop.
0x0010 Hexadecimal
number
A hexadecimal number is identified by being preceded by
an „0x“ (here: 16 decimal).