Instructions / Assembly

5.
Lay out Top G4 Pole (8),joint each section Connector to a
straight line as shown.
Assemble the remaining Top G4 Pole (8) in the same way.
Spread the Netting (10) on the trampoline bed, insert a Top
G4 Pole (8) into the opening of Top Sleeve on the Netting
(10). Insert the other Top G4 Pole (8) into the
opposite opening of Top Sleeve on the Netting (10).
5 a
Joint each end of Top G4 Pole (8) by the clip of connector
at each opening. The Top Sleeve of the Netting (10)
become a round shape.
6.
Netting (10) with the G4 Pole (8) to the Plastic Enclosure Cap (9)
Attach the first hanging point at the upper edge of the
of Enclosure Top Tube(7). Attach a second hanging point
directly across the Netting (10) from the first hanging point.

Attach the other two hanging point halfway between the
first two hanging points,so four hanging points are
attached as shown.
6 a
Plastic Enclosure cap(9)
Hanging point 1
Hanging point 2
Hanging point 3
Hanging point 4
5
Spread out G4 Pole and Joint each section
to one straight line.
Opening
(8)
Netting (10)
Insert the pole into sleeve of the Netting (10)
6
Joint the end of each pole by Clip of Connector
Black G4
Black G4
Black G4
Black G4
Top Sleeve
Door of Netting
Netting (10)
Door of Netting
10
%/8(
%/8(%/8( %/8(
%/$&.
%/$&.