Instructions / Assembly

See insert drawing for attached of G4 Pole (8):
Plastic Enclosure Cap (9) has been attached to the
top of the Enclosure top tube(7).
7
7. Note: During steps 7 and 8, you will “sew”the
lower edge of the Netting(10) to the V-rings on the
bed using the Cords(12).
Locate the V-ring closest to the door. Thread one
end of a Cord(12)through the lower edge of the
Netting(10)above the V-ring and then thread the
Cord through the V-ring. Tie the Netting to the
V-ring, by making a double knot in the Cord.
8
Thread the Cord(12) through the lower edge
of the Netting(10) halfway between the first
V-ring and the V-ring to the left, and then
thread the Cord through the V-ring to the left.
Repeat this procedure until the entire Cord is
threaded through the Netting and the V-rings
as shown. Keep the Cord taut. Tie the end of
the Cord to the last V-ring that it reaches.
Tie a second Cord(not shown)to the last V-ring
reached by the first Cord. Thread the second
Cord through the Netting(10) and the V-ring
as described above. Repeat this procedure
with the remaining Cords until the last Cord
reaches the first Cord. (Note: The last Cord
may overlap the first Cord.) Make sure that the
Netting is sewn to every V-ring on the
trampoline bed; the Netting below the door
must also be sewn to the V-rings.
8.
9
Attached Hanging Point :
Plastic Enclosure Cap
G4 Pole (8)
Top Tube
(7)
Netting
Door
Door
10
10
V-ring
12
12
V-rings
Strap