Instructions / Assembly

9
3.
2
2. Lay a Enclosure bottom tube(6) and a Enclosure
top tube(7) with Plastic Cap on the ground.
Make sure that the Enclosure bottom tube(6) is
oriented so the small holes are in the position shown.
Slide a Foam Sleeve (11) onto each of the tubes;
note that the ends of the Enclosure bottom tube(6)
should not be covered.
Insert the Enclosure bottom tube(6) into the Enclosure
top tube(7).
Tighten a Self-tapping Screw (5) into the small hole
in the Tube (6, 7).
Slide a ‘WEDGE’ (4) onto the Enclosure bottom tube(6),
the top of the ‘WEDGE’ (4) should touch the bottom of the
connector, and the bottom of ‘WEDGE’ (4) should be even
with the end of Enclosure bottom tube (6).
Next, slide one of the U-bolts (3) up until it touches the
bottom of the Socket, and tighten the two Lock-nuts (1)
on the U-bolt. Slide the other U-bolt up until it is 2”above
the lower end of the Enclosure top tube,and tighten the
two Locknuts on the U-bolt.
4. Attach the other three tubes (6,7) in the same way.
See insert drawing.
T-connector
13
11
9
9
11
6
5
7
Plastic Cap
Plastic Cap
Small Hole
Tighten Self-tapping screw
Into Small Hole
1
1
2
3
3
4
4
7
(11)
(6)
(15)
Straight Pole
Foam Sleeve
Wedge
Self-tapping screw
for Wedge
Screw Hole
Screw Hole
(4)
Bottom Plastic Cap
2.a
2.a Use Self-tapping Screw for Wedge(15) to Screw
the Wedge to the bottom pole(6).
Assemble the remaining bottom tubes(6), Top
Tubes (7), and Foam Sleeves(11) in the same way.