Instructions / Assembly

Model# JK13S017

The trampoline/ enclosure is designed for users weighing 90kg (200 lbs.) or less.

Ladder is not supplied with trampoline.

This enclosure is to be used only in connection with certain trampolines.

Use the trampoline and trampoline enclosure only with mature knowledgeable

supervision.

PAGE 1
Model# JK13S017 The trampoline/ enclosure is designed for users weighing 90kg (200 lbs.) or less. Ladder is not supplied with trampoline. This enclosure is to be used only in connection with certain trampolines. Use the trampoline and trampoline enclosure only with mature knowledgeable supervision.
PAGE 2
PAGE 3
PAGE 4
PAGE 5
PAGE 6
PAGE 7
PAGE 8
PAGE 9
PAGE 10
PAGE 11
PAGE 12
PAGE 13
PAGE 14
PAGE 15
PAGE 16
(see illustration)
PAGE 17
PAGE 18
Lay a straight enclosure pole(12) and a curved enclosure pole(13) with plastic cap on the ground. Make sure that the straight enclosure pole(12) is oriented so the small holes are in position shown. Slide a foam sleeve(16) onto each of the tubes; note that the ends of the straight enclosure pole(12) should not be covered. Insert the straight enclosure pole(12) into the curved enclosure pole(13). Tighten a self-tapping screw(11) into the small hole in the poles(12 & 13).
PAGE 19
19 19 15 19 15 19 15 19 9b 15 19 15 15 Attach the first hanging point at the upper edge of the netting(15) with the rod to the plastic cap(14) of curved enclosure pole(13). Attach a second hanging point directly across the netting(15) from the first hanging point. curved enclosure pole(13) See inset drawing for attached of rod: Plastic cap(14) has been attached to the top of the curved enclosure pole(13).
PAGE 20
PAGE 21
200
PAGE 22
19 Straight enclosure pole Curved enclosure pole 19 2