Operation Manual

3534

It is also helpful for picking up the signal to set the appropriate time

zone for your location, as an attempt at synchronisation always begins

at c. 2 a.m. based on the local time set on the watch. If the time zone is

wrong, the watch will try to synchronise with the time signal transmit-

ter that was previously set.

For example: You travel from Europe to Japan. Your watch has CET

saved and tries to synchronise in line with CET at 10 a.m. in Japan. At

that time of day interference is disproportionately greater than when

synchronising at night and the chances of optimum reception are thus

less.

With the time zone set correctly the appropriate transmitter frequen-

cy gets checked as the first priority, thus reducing the length of the

transmitter check and power consumption.

Important note:

When you travel into a different reception area (e.g. travelling from

Germany to Japan), automatic time and transmitter synchronisation

does not take place until the watch next picks up a time signal. If the

watch fails to pick up a time signal, perform a manual transmitter call

(see section 6.1).

4. Functions

Please note: depending on model, your Junghans multi-frequency

radio-solar watch is equipped with pushers or correctors embedded

into the case. To operate the embedded correctors please use a suit -

able pointed tool.

Key lock (depending on model)

Depending on the model of your Junghans multi-frequency radio -

solar watch you have the option of locking the T2 key.

Key lock via security cover:

Slide the security cover between T1 and T2

down wards (in the direction of T2) until it clicks

into place and the red marking is visible.

Sliding the security cover back up (in the direc-

tion of T1) means that all functions of T2 are

available again.

Key lock via crown:

Rotate the crown until it clicks into place and

the red marking is visible, as in the illustration

on the left.

Rotate the crown halfway and all functions of

T2 are available again.