Instruction Manual

ETX 513/515
High level of eciency from ‘manual’
to ‘automatic’.
The ETX can be adapted for use in any
warehouse or for any application thanks
to its modularity and innovative control
technology. Irrespective of whether your
warehouse is manual, semi-automatic or
fully automatic: The ETX has the appro-
priate technology on board.
• RFID technology for truck positioning
in narrow aisles
• Inductive guidance with multi-frequen-
cy control
• Redundant route and height measure-
ment
• Active reach control with correction of
the mast backward tilt
• Warehouse navigation with precise ap-
proach and automatic stacking
• Load handling alternatively by sideshift
or telescopic forks
Modules for automation
• Automation computer with radio mod-
ule for data transfer
• System interface for communication
with the warehouse management
computer
• Apron navigation by means of inductive
guidance and cornering by RFID con-
trol
• Redundant safety cut-outs via unblock
frequency or warehouse management
computer
• Precise positioning for safe lifting of
loads
• Optional with centring frame, per-
imeter monitoring and gap check (tele-
scopic forks)
• No-load sensor
• Built-in charger with busbar oper-
ation for three-shift operation without
battery change
• Personal protection system (PPS)
Prerequisite for automation
When justifying automation and the
requirements which are necessary, our
system consultants should be consulted
in advance of a project. Here are a few
examples of what is to be considered:
• Warehouse control and processes
must be configurable for an automated
system (warehouse management com-
puter, warehouse management system)
• Configure warehouse environment
accordingly (conveyor technology,
defined transfer positions)
• Uniform loads if possible (max. two
loads; observe the quality of the load
carrier)
• Observe tolerances for floors and
racking systems
• Area security and access monitoring
• Maximum lift heights on request
Design, commissioning and service
from a single source
We oer you:
• Design, planning and development
• Material flow, capacity planning and
calculation of economic eciency
• Fork lift trucks and racking
• Hardware and software for warehouse
management and control
• Design and commissioning
• Service and support for all system
components