Declaration of Conformity

2.4 Using the Transponder Reader

NOTE

Do not damage the transponders. The module cannot be switched on with damaged

transponders.

2.4.1 Activating the Module with a Transponder

Procedure

• Release the emergency disconnect switch.

• Hold a transponder in front of thetransponder

read area (4).

A green tick appears and remains until the

transponder has been confirmed. If there is no

confirmation within 20 seconds, the access

prompt appears.

• Press the key below the "Confirm" symbol (9).

The module is enabled.

2.4.2 Blocking an Enabled Module

Procedure

• Press the key under the "Switch off" symbol (5) on

thedisplay unit.

• Press the emergency disconnect switch.

The module is blocked.

As an option, the customer service department can pre-set the module such that the

module is blocked automatically after a defined delay at a standstill. Automatic

blocking does not occur if the module has been enabled by the set-up code or the

set-up transponder.