User Manual

Installing a Trapeze Networks™ Model MP-620 Mobility Point™ Access Point
7
Connect Cables to the MP-620
3 Apply weatherproofing tape to the antenna connectors to help prevent water entering the connectors.
Figure 4. Connecting External Antennas to the MP-620
Connect Cables to the MP-620
1 Attach the Ethernet cable to the Ethernet port on the MP-620.
2 For extra protection against rain or moisture, apply weatherproofing tape (not included) around the
Ethernet connector.
3 Be sure to ground the unit with an appropriate grounding wire (not included) by attaching it to the
grounding screw on the unit.
Note. The Ethernet cable included with the package is 30 m (100 ft) long. To
wire a longer cable (maximum 100 m, 325 ft), use the connector pinout
information in the Installation Guide.
Caution! Be sure that grounding is available and that it meets local and
national electrical codes. For additional lightning protection, use lightning rods,
lightning arrestors, or surge suppressors.
RF Coaxial Cable
2.4 GHz External
Omnidirectional
Antenna
2.4 GHz
N-type Connector
5 GHz
N-type Connector
5 GHz External
High-gain Panel
Antenna
MP-620