User Manual

Installing a Trapeze Networks™ Model MP-620 Mobility Point™ Access Point
9
Configure the MP-620
Figure 6. Connecting Cables to the Power Injector
3 Insert the power cable plug directly into the standard AC receptacle on the power injector.
4 Plug the other end of the power cable into a grounded, 3-pin socket, AC power source.
5 Check the LED on top of the power injector to be sure that power is being supplied to the MP-620
through the Ethernet connection.
Configure the MP-620
To configure the channels, power settings, and other MP parameters, see the following:
z Trapeze Mobility System Software Quick Start Guide
z “Configuring MP Access Points” chapter in the Trapeze Mobility System Software Configuration
Guide
Note. For International use, you may need to change the AC line cord. You
must use a line cord set that has been approved for the receptacle type in your
country.
Input
O
utput
Ethernet cable
from LAN switch
Ethernet cable to
MP-620
AC power
Power LED indicator